Friday, April 18, 2014

Placed the last two bulkheads

I first place the wet cell bulkhead with a filled  and after the lunch a place a tape over it. We then started with the entrance bulkhead, after some shopping we did a tape over the filled. I placed a half of the dagger board case to look how big the entrance to the the head is. It looks big enough maybe only cut some small strip out of the head bulkhead to make it bigger.



Sunday, April 13, 2014

place head bulkhead

We first picked up the trampoline for Thrill Seeker but we arrived at twelve and the first cast could come any moment so we are now planning to install it after our work during the week. After the lunch we did place the head bulkhead. This is the largest bulkhead so the tape did take some time but this time we were finish at four and decided it was enough for today.




Saturday, April 12, 2014

busy day

In the morning we did the after beam bulkhead and in the afternoon we went to Thrill Seeker to put the motor and the trampolines on. After we were half way with one trampoline we saw that tube was not going to fit in the new sleeve. So we had to disassemble it :-( again and bring it to the maker of it again. Maybe we can do them tomorrow but the time is limited because they have a party where the boat is standing.
After we did bring the trampoline we decided to do the front beam panel, when were finished it was 20:30



Friday, April 11, 2014

back panel

This morning I went to Nico to swap some stuff ;-), he is going to shape my daggerboard and I am going to fix his foil slider case. In the late afternoon I did the back panel, I did this in one shot, I now had more room because the support battens were not in the way.

Wednesday, April 9, 2014

taped the panels

I first made a filled and waited an hour or so before I started to tape the panels. The filled is than hard enough to stay in shape. I laid a folly in the hull to wet out the carbon tape (seen in the picture).

Tuesday, April 8, 2014

placed first three panels

I placed the first three panels. I glued them but not with some fillets yet, I am planning to do the fillets and the tape tomorrow.


Sunday, April 6, 2014

placed the extra layer centred on frame 6

First we did some painting work on Thrill Seeker in the morning and after the lunch we laid the extra layer centred on frame 6. Now we can finally place some bulkheads and make some visual progress.


 

Saturday, April 5, 2014

Middle upper laminat

We did the middle part today what was a little struggle because you tend to stand on the fresh laminate, but in the end it was still ok.
I think the other half will be done different, think of doing first the side before making the roof. The next thing before I can do the bulkheads is putting an extra layer 400 gr centred on the front bulkhead from bottom to roof. Tomorrow we do some paintwork on Thrill Seeker.