Friday, August 16, 2013

Laminating the other side

We did the other side today, building is a little bit addictive, normally we go sailing but we want to make some progress. Tomorrow we going to unpack again, what is alway exciting.



Monday, August 12, 2013

unpacking like little kids

We did unpack just when we arrived from work if we were little kids who get birthday presents ;-)
The result was very nice, we had some some little pinholes but it was better than I expected. I did weight the float and it was now 65 kg with one side and a nose cone to go.








Sunday, August 11, 2013

first outside laminate

Today we did do the first outside, it took us some four hours to do the job. I first glued the vacuum back to the underside before we started to laminate. This made it easier and faster to seal the back. vacuum was
-0,8 bar and I adjusted it back to -0,65 bar to make the laminate not to dry.




Saturday, August 10, 2013

last preparation for outside laminate

Yesterday and today I did the last preparation for the outside laminate. I put some putty on the foam where the tacky tape for the vacuum is put on. Tomorrow I faire it a bit and then I put the tape on and then we can laminate the outside. Yesterday I laminated the second phase of the collar slide, first I thought doing it with vacuum but after seen the result of Nico's I decided to do it without it. The result was nice, with a block of wood I could easily get it loss of the mold. I also laminate the foil case after a rebate of some HD putty, this is necessary because the case get some more layers of  fabric in and around the case.





Sunday, July 28, 2013

Started with foil collar slide



Yesterday we had a code red for the weather so no sailing. I made some holes for the hatch fasteners and filled them with glas and micro balloons. When the float is laminate on the outside there will be on thin layer where the hatch is so the filled holes and edge will be covered. Today I started with foil collar slide you can also see this with Nico's his F85. With the rest of the epoxy I made some filler to fill some low spots around the chainplate.






Friday, July 26, 2013

Inside hatch rim lamination

Our first plan for the weekend was to go with some other tri's to go to the Waddenzee but the weather what looked good in the begin of the week turned to nod so good. So we change plan to not go sailing on friday and make an other trip on saturday and sunday. So I thought what can we do on Thriller and I then realised that I had to do the inside hatch rim, first I had the plan to do it with vacuum but after an half an our struggling with the tackytape I gave up and did an ordinary hand layup. After drying it did not look bad and the hatch still fits.




Thursday, July 25, 2013

Stern laminate

Today I did laminate the stern so we almost there to do the rest of the outside. At the moment it is hot and I had to laminate quick. Before we can do the outside I have to do some shopping for Epoxy resin and some other materials but my supplier will be back next week from vacation.