Laminating the inside part three

During the week I did some preparation work again so we could laminate the inside today.

placed HD pieces

Today I first scrape the putty what I did yesterday and after that I started to measure where all the HD piece had to come. For the other half I did take some notes and pictures so it was not so difficult. I then cut some HD pieces and glued them with PU glue.

foam placed for the deck

Today it was a long day, first we unpacked our work of yesterday and after that it took me the rest of the day to put all the foam for the deck in place, after dinner I did some putty in the corners so I can scrape it tomorrow and place the HD pieces.

 

Laminating the inside part two

Over the week I did some small things in the evening like placing the HD foam for the mast raising and putty some corners so that I could laminate the side today. This session took us three and a half hour and we had a nice vacuum. Tomorrow I can start to place the foam for the deck.

put the side panels in place

We first unpacked the work of yesterday and cut of the extra foam at the bottom. I then started to mount the battens for the side foam panels. The panel mounting went very quick because you can mount 120 cm wide panels and they are almost flat so you don't need heat to form. I glued the panels together with PU glue and the seams were later done with putty. The HD piece for the diagonal braces are placed also, I only have to fit the mast raising HD pieces but had no time anymore so this will be for the next time.

First part of the inside done

We do the inside in three stages, this is better to manage than in two as we did with the other half. Still this part is very tiresome because you have to reach fare but not so much as with the first part the other half. That took us seven hours. This time it took us five hours.

 

prepared the bottom for laminating

This weekend is not the nicest weather to sail so we are building again. I started to scrape and sanding all the putty. This did take few hours of hard labor and sweat. On the end of the day I put the tacky tape on the edges of the foam and made a start with the cut of some peel ply and breeder folly. Tomorrow I cut the rest of the stuff.