We spent the hole day on putting five layers of anti-fouling on the bottom and the result did not look bad.
Saturday, December 3, 2016
Friday, December 2, 2016
Preparing the bottom
Yesterday morning I sanded the dagger board slot and put a last primer on it. In the afternoon we did pick-up our trailer. It is a second hand one what was to small for my comfort and the axles had to replaced to EU standard. Today I did find out they did made it to wide, I asked for 2,35 m and they made it 2,53 m. So it will be brought back in January, and it was no problem. In the meantime I can trial fit the cradle so they can also adjust some support what have to come off.
Today I spend most off the time in preparing the bottom with sanding and cleaning. I also did a trial fit off the dagger board upside down to look if the slot was ok, I had to sand a little away and it now fits. On the end of the day I put some masking tape on the waterline and a tape with some plastic on it to protect the paint from anti-fouling spatters.

Today I spend most off the time in preparing the bottom with sanding and cleaning. I also did a trial fit off the dagger board upside down to look if the slot was ok, I had to sand a little away and it now fits. On the end of the day I put some masking tape on the waterline and a tape with some plastic on it to protect the paint from anti-fouling spatters.
Tuesday, November 29, 2016
finishing the dagger board case slot
Monday, November 28, 2016
Painted the other side
Fetske did paint today the other side of the main hull. I went to the shed tonight with Fetske to look how it looked. I also cut a ruff hole in the laminated of the dagger board slot. I have tomorrow afternoon free so I can finish it and put some filler or primer on it to make it ready for the anti-fouling paint. I will also tape the waterline so Fetske can do a second layer of DD paint on it on Wednesday
Sunday, November 27, 2016
Painting the main hull
In the morning I started with the dagger board case slot to sand it and to fill some holes. When that was done I laminated a thin layer of carbon over it to make it a bit stronger. I than did give the dagger board an other layer of paint. After the lunch we watched the F1 grand prix. After the finish we went to the shed again, Fetske did a final layer of paint against the sealing and I put on one side a thin layer of paint. Maybe Fetske will do the other side tomorrow.
Saturday, November 26, 2016
glued the dagger board slot in place
In the morning I started with putting some primer on the beams and the underside of the cradle in the garage. I then went to the shed to make the slot fit and cut it in three pieces. I drilled some small holes in the top of the slot pieces and screwed a piece of foam on it to hold it even with the bottom. In the afternoon I glued it all in place and put some pieces of foam in the center to press it to the sides. After some cleaning of the table and the dagger board I started with DD paint om the dagger board.

Tuesday, November 22, 2016
dagger board slot from the mold
Subscribe to:
Posts (Atom)