Sunday, December 18, 2016

Turned back

Today my friends Rob and Reijer went by to help us turn the boat around. I took us the morning to turn it around and in the afternoon we made the supports to hold the boat level. We did stop early to have some nice dinner what Fetske made and celebrated the turning. I have made a time laps video but I must make it on YouTube and with the new computer I have to find my way again to do it.







Saturday, December 17, 2016

Ready for turning

Yesterday I glued the SP unit for the fridge in the hull and sanded the bottom. I did also shorten the vertical support webs of the cradle. The after support was a little short so I glued a off-cut from the others to it. The front and the back support will be longer because I bolt them to the existing trailer tubes, the middle ones will be placed on some aluminum profiles. Today I taped the support webs and made some room in the shed so we can turn the boat over tomorrow.



Sunday, December 11, 2016

Placed the after support web in place for the cradle

I started the morning with the after support to glue it in place with some putty and make a nice filled in the corners. After some shopping and lunch the filled was a little stronger but still tacky, I tape over it with some glass tapes without harming the filled much. After a tea break we went to the shed to put another layer of paint on the underside, I hope this will be the last one. For next weekend we have plant to turn the boat back again.







Saturday, December 10, 2016

Started with the plug for the rudder mold

Yesterday we painted the hole hull so all the blue spots were almost gone, did did little shine thru the paint. I also painted the dagger board for the last time for the moment. I have to decide if I paint it jello or orange. Today we went shopping for some MDF to make a plug for the rudder mold. We did buy some painted MDF because this stays more stable and strait when it is routed. I got this tip from Nico and he got it from Henny. In the afternoon I started with cutting the pieces and to glue them together. One half is made up from 12 mm and 9 mm. Nico did make a nice drawing so I did exactly know what to cut. When that was ready I did another paint layer on the whole boat. The blue spots are hardly to see now and it looks good. Tomorrow I put another layer on it.






Sunday, December 4, 2016

Blue spots

I sanded the hole hull to make it smoother for the next layers of paint and you can better see all the low spots, pin holes and scratches. While I was sanding Fetske did marked the spots what did need some attention.
I then put some blue filler on all the spots. In the afternoon I painted the dagger board and some other loose panels and with the rest of the paint I did the back of the hull. I took the painting stuff home to give the tops off the beams also a layer of paint.





Saturday, December 3, 2016

Put some anti-fouling on the bottom

We spent the hole day on putting five layers of anti-fouling on the bottom and the result did not look bad.

Friday, December 2, 2016

Preparing the bottom

Yesterday morning I sanded the dagger board slot and put a last primer on it. In the afternoon we did pick-up our trailer. It is a second hand one what was to small for my comfort and the axles had to replaced to EU standard.  Today I did find out they did made it to wide, I asked for 2,35 m and they made it 2,53 m.  So it will be brought back in January, and it was no problem. In the meantime I can trial fit the cradle so they can also adjust some support what have to come off.
Today I spend most off the time in preparing the bottom with sanding and cleaning. I also did a trial fit off the dagger board upside down to look if the slot was ok, I had to sand a little away and it now fits. On the end of the day I put some masking tape on the waterline and a tape with some plastic on it to protect the paint from anti-fouling spatters.