Monday, June 13, 2016

put a double on the backside

I took the afternoon free and started with cutting some foam pieces for the back and glue them on the back with PU construction glue. When that was drying I sanded the complete deck. I then cut some carbon pieces to tape them over the foam and the front seam of the deck and the top of the water ballast top. When that was laminated I discovered that one side foam panel was not completely glued, so I drilled some holes in the foam and squeezed some epoxy putty under the foam and put some clamps on it.

Sunday, June 12, 2016

some racing again and a bit building

We went friday afternoon for some sailing underway to the racing ground, we went early because there was not so much wind promised. Saturday we had only a bit of rain in the morning but in the afternoon when we had to race we had nice sunny weather with only a light breeze. It took us two hours to complete one race because we had some wind holes. We stopped after one race to claim some places in the shelter harbour. The weather stayed dry so we had a nice BBQ. On sunday there was no wind and it was not coming either. We motored home and in the afternoon I did some work on Thriller. The aftersides need some dubbeling. I started with the top half made from scrap pieces. The next time I will do the back underside. I finaly I put some blue filler on some spots.






Friday, June 10, 2016

sanded and primed the inside of the beam mounts

I sanded and primed the inside of the beam mounts this morning, not the most fun job because of the tight space. This was the first layer of primer, when the second is done I can see were it need some filler. In the afternoon we are going to sail and tomorrow and sunday we have some friendly races with BBQ.

Wednesday, June 8, 2016

Glued the after deck on the water ballast tank

I took some hours free again and this time I glued the after deck on the water ballast. When that was done I rolled a second layer primer on the topside.

Tuesday, June 7, 2016

put some primer on the deck

I took some hours free to do something on the boat. I started to sand the blue filler and to sand the side of the nose. When I had enough of the sanding I decided to do the deck with some primer. This layer gives a better view of of some spots what need some filler.

Sunday, June 5, 2016

put a filler on the inside of the beam mounts

Friday I sanded the sides and the nose in the morning and had to go to a reunion so I had no time to post something, on the way I picked up some primer to put over the filler. Saturday we went for some sailing in light air and only some wind on the end with a max speed of 10 kn. Sunday we had wind from the begin with a max speed of 12 kn. So we were quick at home and I did some filler on the inside of the beam mounts and the sides of the outside bunks. I bought a new second hand teleflex unit for my Spinlock throttle. I is a top mount unit but it can easily converted to take of the side plates.













Wednesday, June 1, 2016

sanded the deck and the upper side

I took two hours free and sanded the deck from the anker well to the entrance and the upper side from the trampoline tube to the deck. I sanded off a half kilo of dust in the vacuum cleaner, I thought I took a picture of all the the dust in the cleaner but it was not on my camera. It was a lot. The deck is now ready for some primer, I only have to sand the edge by hand to give it a little rounding.