Almost togetter

Today I placed the vend hoses, did dig out some foam around the foil case and prepared the hull for the join.

chain plate fitted

To night I did fit a chain plate in the bulkhead, it was a little bit a trapeze act because the hull is hanging on the sealing but it wend well and much quicker then with my F31 because you can reach it much easier now the hulls are not glued together. I also fitted some vent joins like Nico did see joiner and vents. Still have no camera and make the pictures with the Ipad and this is not optimal.

An other day at the office

Today we did laminate hull three, it is almost production ;-) The vacuum was perfect ones again. The trick I use to get a good vacuum is to heat the tacky tape with a heat gun after I put it on the foam, see first picture. It sticks then very good. The two week schedule is not going to continue because I have to work next Saturday and we have a meeting of our multihull club CTC

not so much to see

Yesterday we made half three with foam and today I filled the seams with putty. Tomorrow we laminate the inside.

turning the frames

We did pull out the float half but before we put it up I made some room on the sealing. The turning off the frames is next and putting back all the battens.

not so mudge light any more

Turning the frame is easy because they fit exactly in the holes 

Number two finished, two to go

Last Sunday we laminated the inside and today I did the bulkheads and tomorrow we pull it out off the frame. I then have to turn the form frames to make the two other halves, I hope I can keep this pace, every two weeks a inside float half.

Result of one day hard work

Yesterday I started at 11:00 and did finish at 23:00 with some breaks for lunch and dinner. On the end off the day I had the frame filled with foam and the seams filled with putty.
Today we did cut some carbon and other stuff for tomorrow. Afterwards I scraped the seams and filled them for the second time to get a good air tided seam.