laminated the front deck

I laminated the front deck on my own, because Fetske was away with her girlfriends. So I decided to do not suds a big part. I started at 12 o'clock and I had the vacuum on it at 15.00. It was going easier than expected and had directly a vacuum of 0,95 and I screwed it back til 0,8 mbar
After that I build a sort of tent to get the temperature up.

Ready to do some laminate

Yesterday and today I did some preparation to do the front tomorrow. I have to laminate on my own so not so big piece. I laid some wood around the hull so I can easier laminated, it looks like surgery;-)

routed the window

Today I did the after top laminat of the daggerboard and filled the hole partially were the HD putty did boil. The window mold we did do together because of the lengte and vertical. After we put it on the right place we screwed it on the foam so I could cut with a stanley knife two edges. The first one was right along the mold the second was with a thin batten against the mold also seen in a early post. This make the routing muts easier and you have a straight edge. The edges are no also rounded ready to laminate over it.

some prep work on the deck

Yesterday I had to work in the evening so my day was a little shorter to do some things and today our parents coming to visit so this day is also a little shorter. Yesterday I scraped and sanded the putty and put some reference lines on the deck. Today I laid some carbon in the daggerboard case and I taped the entrance bulkhead so that is easier with the vacuum and the tacky tape if I do the deck. I had a small misfortune withe HD putty on the back of the daggerboard case what started to boil and had to be removed.

fairing and putty the deck

Today I fared the deck and cut the exes deck foam at the entrance. I partly cut the exes carbon of the daggerboard case on the deck and pulled out some foam and filled it with HD putty so I can later make a round edge to laminate over it in the case.
The place of the mast step had to be filed to partially, I did this with some layers carbon. Finally I filed the edges and holes with putty.

Hanging free

Today  we cleared the rest of the frames with my dad and my friend Rob. After the clearing Fetske helped also to turn it in the upright position. After lunch Rob and I first repaired our cutting tools and after that we cleared the foam edges with the cutter and the long boards. Before we went home we did take a look to see how the inside looked and the head entrance was very nice. Tomorrow I start with filling of the edges and hole of the upper half

Almost free

We have been on vacation for a week so there was no progress. Today we started to lift the boat out of the frames and it is almost free. The rest of the frames will be done tomorrow, five to go