Friday, October 9, 2015

put the backrest in place

I start this morning to make some planks to get the same angle of the backrest as the other, I than glued and tape the back of the backrest. After that I cut the tops of the coming of HD foam. In the afternoon I cut all the necessary stuff to do some vacuum yob of the kitchen panel and the HD foam tops. I came also to the conclusion that I run out of the 400gr carbon, so I did take some extra layers 300gr on the HD tops. After I did vacuum on the table I inspected the backrest and it was already settled so I could take the planks away and taped the front of it also.

No comments:

Post a Comment