Friday, January 29, 2016

laminated the inside of the escape hatch

I started this morning to to lay some glass on the place where the bailers will come, used glass because the bailers are RVS and I think it is better to isolated them from the carbon. After that I filled the edges of the holding tank inspection port. In the afternoon I first screwed the escape hatch to the hull so I could see were the bolds later will come. I drilled the foam away around the screw holes and I filled them with putty. I then laminated over the inside foam. On the end of the day I glued a rib for the raised floor in place, no picture of this.

No comments:

Post a Comment